Juniper-networks SRX 210 Bedienungsanleitung PDF herunterladen (Seite 89)

TIP: When youare powering off the device, the system displays the following

message: Turning the system power off. You can now safely remove the power

cable to completely disconnect the power from the device.

NOTE: You can use the request system reboot command toschedule a reboot

of the services gateway.

For more information about halting, powering off, or rebooting the services gateway using

the CLI, see the following topics:

•

Initial Configuration for Security Devices

•

Monitoring and Troubleshooting for Security Devices

Resetting the SRX210 Services Gateway

The Reset Config button located at the front panel of the SRX210 Services Gateway

removes the current configuration and resets the device to the default configuration. The

button is recessed in the front panel to prevent it from being pressed accidentally.

NOTE: Pressing and holding the Reset Config button for 15 seconds or more

deletes all configurations on the device and loads and commits the factory

configuration.

Documentation

• Connecting the SRX210 Services Gateway to the Power Supply on page 67

• Grounding the SRX210 Services Gateway on page 70

• SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High

Memory, and PoE Versions) on page 9

• Using the Reset Config Button on the SRX210 Services Gateway on page 109

• SRX210 Services Gateway LEDs on page 13

Chapter 12: Connecting, Grounding, and Powering On the SRX210 Services Gateway

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 175 176

Keine Kommentare

Juniper-networks SRX 210 Bedienungsanleitung Seite 89