
J4350 and J6350 Services Router Getting Started Guide
Rack Requirements
J4350 and J63 5 0 Services Routers must be i nstalled in a rack. Many types of
racks are acce
ptable, inclu ding front-mount racks, four-post (te lco) racks, and
center-mount racks.
The following sections describe rack requirements:
Rack Size and S
trength on p ag e 72
Connection to Building Structure on page 73
Rack Size and Strength
The Services Router is designed for installation in a rack that co mplies
with either of the following standards:
A 19-in. rack as defined in Cabinets, Racks, Panels, and Assoc iated Equipment
(document n u
mber EIA-310-D) published by the Electronics Industry
Association (
http://www.eia.org)
A 600-mm rack as defined in the four-part Equipment Engineering (EE);
European telecommunications standard for equipment practice (document
numbers ETS
300 119-1 through 119-4) published by the European
Telecommunications Standards Institute (
http://www.etsi.org)
The horizontal spacing between the rails in a rack that complies with this
standard is usually wider than the router’s mounting ears, which measure
19 in. (48.2
cm) from outer edge to outer edge. Use approved wing devices to
narrow the opening between the rails as required.
The rack rails must be spac ed widely enough to accommodate the
router chassis’s external dimensions: 3.4 in high (8.7 cm), 17.4 in. wide
(44.3 cm),
and21.1in. (53.7cm)deep.
The outer e
dges of th e mou ntin g ears extend the width of either chassis
to 19 in. (48.2 cm), and the front of the chassis extends approximately
0.5 in. (1.27 c m ) beyond the mounting ears. Th e sp acing of rails and
adjacent
racks must also allow for the clearances around the router and
rack. (See “General Site Guidelines” on page 71.)
CAUTION: I
fyouaremountingtherouterinacabinet,besurethatventilation
is sufficient to prevent overheating.
If a front-mount rack is used, we recommend supporting the back of the router
with a shelf or other structure.
72 Rack Requirements
Kommentare zu diesen Handbüchern