Juniper-networks J4350 Bedienungsanleitung PDF herunterladen (Seite 120)

J4350 and J6350 Services Router Getting Started Guide

To connect to the J-Web interface through port 0 on the router (see Figure 35):

1. On the management device, such as a PC o r laptop, you u se to access the

J-Web inte rfa

ce, verify that the address of the port tha t you connect to the

router is set to one of the following:

An Ethernet ad

dress on the

192.168.1/24 subnetwork other than

192.168.1.1

An Ethernet address from a DHCP server

2. Turn off the power to the managem ent device.

3. Plug one end o

f the Ethernet cable into the Ethernet port on the management

device.

4. Connect the o

ther end of the Ethernet cable to the built-in Ethernet port

on the router.

5. Power on the r

outer by p ressing the power button on the front panel.

6. Wait until the STATUS LED on the front panel turns solid green.

7. Turn on the power to the management device. The router assigns an IP

address to the management device within the

192.168.1.0/24 subnetwork if the

device is con

figured to use DHCP.

8. From the management device, open a Web browser and enter the IP address

192.168.1.

in the address f ield. The S et Up Q uick Configuration page appears.

9. Configure basic settings for your router as described in “Configur ing Basic

Settings wi

th J-Web Quick Configuration” o n page 10 5 .

NOTE: You must manually co nfig ure the IP address for the m a na gement port

you are usin

g before you save your initial configuration. When you save the

configuration for the first tim e, you will lose the con nection to the router if you

have not manually configured the IP address. If you lose connection through the

management

interface, you mu s t connect through the co nsole port.

100 Connecting to a Services Router

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 283 284

Keine Kommentare

Juniper-networks J4350 Bedienungsanleitung Seite 120