Juniper Networks 200 Series Bedienungsanleitung PDF herunterladen (Seite 13)

The Rear Panel

NetScreen-200 Series 7

Power Fuse

Each NetScreen-200 Series device uses a 2.5 Amp, slow-blow power fuse rated

for 250 Volts.

To replace a fuse on a NetScreen-200 Series device:

1. Take the device off-line by turning the power switch OFF and disconnecting the

power cable.

2. Using a screwdriver, separate the lid of the external fuse cover from the surface

of the power outlet.

3. Gently remove the fuse assembly.

4. Slide the new fuse into the opening until the fuse clicks into place.

5. Replace the power cable, then turn the device power switch ON.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Keine Kommentare

Juniper Networks 200 Series Bedienungsanleitung Seite 13