Juniper-networks T1600 Bedienungsanleitung PDF herunterladen (Seite 13)

Figure 6: Typical DC Source Cabling to the T1600 Routing Node

Provisioning Additional Power for the T1600 Routing Node

For a maximally configured T1600 routing node, we recommend that you provision

at least 64 A @ –48 VDC for each power supply input in the system.

We recommend that you provision a facility circuit breaker for each DC power supply

input rated for at least 125% of the continuous current that the input draws at

–48 VDC.

Replacing the Rear Fan Tray

NOTE: If the rear fan tray (model number FAN-REAR-TX-T640-S) is already installed,

replacing the rear fan tray is not necessary. Proceed to “Upgrading the DC Power

Supplies” on page 17.

The rear fan tray is hot-insertable and hot-removable. To replace a fan tray, use the

following procedures:

■ Removing the Rear Fan Tray on page 14

■ Installing a Rear Fan Tray on page 15

Replacing the Rear Fan Tray ■ 13

Replacing the Rear Fan Tray

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Keine Kommentare

Juniper-networks T1600 Bedienungsanleitung Seite 13