Juniper-networks T1600 Bedienungsanleitung Seite 31

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 151
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 30
Circuit cross-connect for leveraging ATM access networks
User-configurable virtual circuit (VC) and virtual path (VP) support
Support for idle cell or unassigned cell transmission
OAM fault management processes alarm indication signal (AIS), remote defect indication
(RDI), and loop cells
Point-to-point and point-to-multipoint mode Layer 2 counters per VC and per VP
Local and remote loopback
ATM Inverse ARP, which enables routers to automatically learn the IP address of the router on
the far end of an ATM PVC
Simple Network Management Protocol (SNMP):
Management Information Base (MIB) 2 (RFC 1213)
ATM MIB (RFC 1695)
SONET MIB
Unspecified bit rate (UBR), non-real-time variable bit rate (VBR), and constant bit rate (CBR)
traffic shaping
Per-VC or per-VP traffic shaping
Support for F4 OAM cells
Support for 16-bit VCI range
Software features
Duplex SC/PC connector (Rx and Tx)
SONET/SDH OC12/STM4 fixed transceivers:
Multimode
Intermediate reach (IR-1)
Optical interface specifications—see SONET/SDH OC12/STM4 Optical Interface Specifications
Cables and connectors
One tricolor per port:
Off—Not enabled
Green—Online with no alarms or failures
Yellow—Online with alarms for remote failures
Red—Active with a local alarm; router has detected a failure
LEDs
31Copyright © 2013, Juniper Networks, Inc.
ATM2 OC12/STM4 IQ PICs (T1600 Router)
Seitenansicht 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 150 151

Kommentare zu diesen Handbüchern

Keine Kommentare